INTELLiVENT-ASV alarm troubleshooting

文章

作者: Elmar Paetzold, Munir Karjaghli

日期: 02.08.2019

The flow charts below provide assistance for resolving some of the most common alarms that may occur when ventilating patients in INTELLiVENT-ASV.

Oscillations

Oscillation Oxygen: Medium priority
Oscillation PEEP/CPAP: Medium priority
Oscillation %MinVol: Medium priority

Workflow for troubleshooting oscillation alarms — Figure 1: Troubleshooting for oscillation alarms

Low SpO2

Oxygen set to 100% due to low SpO2: Medium priority

Cannet meet target

ASV cannot meet the target: Low priority

Workflow for troubleshooting if ASV cannot meet target — Figure 3: Troubleshooting for ASV cannot meet target alarm

Controller at limit

Ventilation controller at limit: Low priority

Oxygen alarm limit exceeded

Oxygen alarm limit exceeded: Medium priority

SBT aborted

SBT aborted: Medium priority

Workflow for troubleshooting if SBT is aborted — Figure 6: Troubleshooting for SBT aborted alarm

SBT fulfilled

SBT successfully fulfilled: Medium priority

Workflow for action when SBT successfully fulfilled alarm is generated — Figure 7: Action required in case of SBT successfully fulfilled alarm

Relevant devices: HAMILTON-G5/S1; HAMILTON-C6; HAMILTON-C3, HAMILTON-C1/T1
Relevant software: HAMILTON-G5/S1 SW v2.81; HAMILTON-C6 SW v1.1.4; HAMILTON-C3 SW v2.0.5; HAMILTON-C1/T1 (SW v3.0.x)